Any ski. Any binding. Any time.
Find Your Pack
Mount a base plate to each ski once. From then on any binding goes on any ski in seconds — alpine, touring, telemark. Now your quiver grows exponentially.
Choose your Setup,
Install in minutes.
Step through the sequence below — installation is simple, and operation is smooth and seamless.
Count your setups
Set your quiver. The number opposite is how many ski-and-binding combinations you can actually ride.
combinations
| Without PUPS | {{ skis }} setups |
| Base plate sets to buy | {{ skis }} |
| Top plate sets to buy | {{ bindings }} |
Triaxial engagement
Rotate the top plate into place and it locks against vertical, horizontal and lateral load at once — a mechanically engaged connection held with a stainless steel locking pin. No slop, no creep, nothing to feel but the snow.
Universal fit
Top plates are pre-drilled for the most popular alpine, touring and telemark patterns. Your binding of choice, any day of the week.
Dynamic mount point
Mount up to ±2 cm* off the recommended line. Park laps at +1.5, big lines at 0 — swapped in minutes, on the same ski.
Leveraged position
Thin is in. 8 mm of stack — thinner than your phone — over a wider footprint than a standard binding, so more of your input reaches the edge.
| {{ row.n }} | {{ row.prop }} | {{ row.val }} | {{ row.note }} |
Find your pack
Built in a garage in Anchorage by two skiers who were tired of choosing between skis instead of riding them all.
